For mobile applications, on the ground and in the air, Vectoflow offers lightweight probes and air data systems. Data evaluation takes place on the systems in real time and the results can be transmitted to a computer or to a flight control system.
The Omni-iProbe from Vectoflow is a compact and lightweight plug & play system for measuring flow velocities and angles for mobile or wind tunnel applications. By combining a 14-hole probe with a data acquisition system, the effort required to determine flow measurements is reduced to a minimum!
Multi-hole probes offer straightforward operation to enable concurrent detection of critical aerodynamic and thermodynamic variables:
Rakes combine several measuring heads in one probe and are therefore ideal for measuring flow variables at several measuring points simultaneously. Rakes can be equipped with the following measuring heads:
High frequency measurement at low speeds. Precise detection and analysis of high-frequency flow phenomena at low speeds.
FRAP Pro is Vectoflow’s transient flow probes that combine the robustness of pressure probes (e.g. 5-hole probes) with a high temporal resolution of the pressure signal. Depending on the probe geometry, frequencies in the kHz range can also be measured.
Vectoflow’s iProbe is a compact and lightweight system for measuring speeds and angles of attack for mobile applications. Fluid dynamic measurements with a multi-hole probe have never been this quick and easy!
The 14-hole Omniprobe from Vectoflow enables measurement of flow angles ranging up to ±160°. Similar to all other multi-hole probes by Vectoflow, the Omniprobe is capable of measuring the following flow parameters:
The VectoDAQ Air Data Computer together with flow measuring probes from Vectoflow forms a compact and lightweight system for measuring flow variables in mobile applications.
VectoVis Professional is a software that provides a comprehensive solution for real-time data acquisition, visualization, and evaluation of Vectoflow's most common sensors and flow probes. It allows users to control traverse systems, configure hardware environments, and customise flow probes. Users can visualize and store both raw and fully evaluated data, as well as define automatic test plans where traverses can be manipulated, data recorded, evaluated and saved. VectoVis Professional is structured with a framework and separate modules tailored for different probe types, ensuring versatility and adaptability to specific measurement needs.
